Sear Station ® Ignition & Usage; Sear Station ® Burner Ignition; To Extinguish - Weber 56524 Owner's Manual

SEAR STATION BURNER IGNITION
®
m DANGER
Failure to open the lid while igniting the barbecue's burners,
or not waiting five minutes to allow the gas to clear if the
barbecue does not light, may result in an explosive flare-up,
which can cause serious bodily injury or death.
The Sear Station burner has an ON or OFF control setting . To ignite the Sear Station
®
burner you must first ignite the two adjacent main burners .
Adjacent Main Burner Snap Ignition
NOTE: Each main burner control knob snap igniter creates a spark from the igniter
electrode to the burner lighting tube. You generate the energy for the spark by pushing
in the control knob and turning to START/HI. This will ignite each individual burner.
m WARNING: Always check hose before using barbecue for
nicks, cracking, abrasions or cuts. If the hose is found to
be damaged in any way, do not use the barbecue. Replace
using only Weber authorised replacement hose. Contact
®
the Customer Service Representative in your area using the
contact information on our web site.
Log onto www.weber.com
A) Open the lid (1) .
B) Make sure all burner control knobs are turned off (2) . (Push control knob in and turn
clockwise to ensure that it is in the OFF position .)
C) Turn on the cylinder valve using one of the appropriate options based on your
cylinder and regulator type (3) .
m WARNING: Do not lean over the open barbecue.
D) Ignite each adjacent Sear Station
turn to START/HI until you hear the igniter snap - continue to hold control knob in for
two seconds . This action will spark the igniter, the burner lighting tube and then the
main burner .
E) Check that the burner is lit by looking through the cooking grates (5) . You should
see a flame . If burner does not light on first try, push control knob in and turn to OFF .
Repeat lighting procedure a second time .
Sear Station Burner Lighting: Ignition by an adjacent ignited main burner
®
F) Turn Sear Station burner control knob to the ON position (6) .
®
G) Verify burner ignition by visual inspection of a flame (7) .
m WARNING: If ignition does not occur within five seconds,
turn burner control OFF, wait five minutes, and repeat steps
F & G, or refer to "SEAR STATION
IGNITION" instructions.
m WARNING: If the burner still does not light, turn the burner
control knob to OFF and wait five minutes to let the gas
clear before you try again or try to light with a match.
Note: Refer to "MAINTENANCE" for burner removal and
cleaning procedure.
◆

TO EXTINGUISH

Push in and turn each burner control knob clockwise to OFF position . Turn gas supply off
at the source .
◆
SEAR STATION
.
®
main burner (4) . Push the control knob in and
®
BURNER MANUAL
®
IGNITION & USAGE
®
®
The grills illustrated in this
Owner's Guide may vary
slightly from model purchased .
2
1
5 7
2
4
6
3
6
OFF ON
www.weber.com
® 21