Canon imageCLASS X LBP1238 II Service Manual page 150

1. In the following service mode, print solid black using A4/LTR size paper.
• TESTMODE > PRINT > PG-TYPE = 2
• TESTMODE > PRINT > START
2. Load the printed paper with the solid black side facing up in a cassette of the machine.
3. In the following service mode, print solid white.
• TESTMODE > PRINT > PG-TYPE = 3
• TESTMODE > PRINT > START
4. When the leading edge of the paper comes out to the Delivery Outlet, open the Front Cover to cause a door open
jam and then close the Front Cover immediately.
CAUTION:
Since pressure is released by opening the Front Cover, accurate fixing nip width cannot be measured while keeping the
Front Cover opened.
5. About 20 seconds afterwards, open the Front Cover and remove the jammed paper.
6. Measure the widths of the glossy part of the toner on the printed paper, and check that they are within the range as
follows.
(Reference value)
• Center (a): 7.1 +/- 1.0 mm
• Edge (b) and (c): 6.7 +/- 1.0 mm
15mm
c
a
Center of paper
b
15mm
140
7. Troubleshooting