Advertisement
Attaching the Presser Foot with
the Included Adapter
You can attach the presser feet using the included
adapter and small screw.
For example, the walking foot, the free motion
echo quilting foot "E", the free motion quilting foot
"C" and so on.
Following procedure shows how to attach the
walking foot as an example.
■ Attaching the Walking Foot
(Optional)
The walking foot holds the fabric between the
presser foot and the feed dogs to feed the fabric.
This enables you to have better fabric control
when sewing difficult fabrics (such as quilted
fabrics or velvet) or fabrics that slip easily (such as
vinyl, leather, or synthetic leather).
Note
• Thread the needle manually when using the
walking foot, or only attach the walking foot
after threading the needle using the
"Automatic Threading" button.
• When sewing with the walking foot, sew at
medium to low speeds.
Memo
• The walking foot can only be used with
straight or zigzag stitch patterns. Reverse
stitches cannot be sewn with the walking
foot. Only select straight or zigzag stitch
patterns with reinforcement stitches. (see
page 83.)
a
Follow the steps in "Removing the Presser
Foot" on the previous page.
CHANGING THE PRESSER FOOT
b
Loosen the screw of the presser foot holder
to remove the presser foot holder.
a Multi- purpose screwdriver
b Presser foot holder screw
c Presser foot holder
c
Remove the screw of the presser foot
completely from the presser foot shaft.
d
Set the adapter on the presser foot bar,
aligning the flat side of the adapter opening
with the flat side of the presser bar. Push it
up as far as possible, and then tighten the
screw securely with the screwdriver.
e
Turn a supplied small screw 2 or 3 times
with your hand.
1
69
Advertisement
Chapters
