Remote Control Functions - Carrier 40MBFAQ Owner's Manual

40MBFAQ: Owner's Manual
DRY Mode
1
3
Boost
Fig. 9 — DRY Mode
1. Press
MODE to select the DRY mode.
2. Set your desired temperature using TEMP
3. Press ON/OFF to start the unit.
FAN Mode
1
3
2
Fig. 10 — FAN Mode
1. Press MODE to select the FAN mode.
2. Press FAN to select the fan speed in the range of AU-100%.
3. Press ON/OFF to start the unit.
CAUTION
EQUIPMENT DAMAGE HAZARD
Failure to follow this caution may result in equipment damage.
Handle the controller with care and avoid getting it wet.
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
2
Humidity
  .
or TEMP
Boost
Humidity

REMOTE CONTROL FUNCTIONS

Press ON/OFF
When the air conditioner is not in operation, the remote control displays
the last set point and mode.
• Press ON/OFF to start the unit
- The unit starts in the last operating mode and set point. The ON/
OFF indicator appears.
• Press ON/OFF to stop the unit
- All the indicator lights on the unit go out, and the remote control
displays the set point and mode.
NOTE: If ON/OFF is pressed too soon after a stop, the compressor
will not start for 3 to 4 minutes due to the inherent protection
against frequent compressor cycling. The unit only emits an
audible beep when the signals are received correctly.
Selecting an Operating Mode
Use OPERATING MODE to select one of the available modes.
Fig. 11 — Operating Modes
Setting the Room Temperature Set Point
 
Press TEMP or TEMP
confirms the signal receipt with a beep and the value of the set
temperature appears on the display and changes accordingly. The
temperature can be set between 62°F (17°C) and 86°F (30°C) in
increments of 1°F or 1°C.
NOTE: In the COOLING mode, if the temperature selected is higher
than the room temperature, the unit will not start. The same
applies for the HEATING mode if the selected temperature is
lower than the room temperature.
Selecting the Fan Speed
AUTO LOW
Fig. 12 — Fan Speeds
Press FAN to select the fan speed.
NOTE: When the unit is on, the fan runs continuously in cooling or
heating. When in heating, there might be situations where
the fan will slow down or shut off to prevent cold blow.
8
to raise or lower the temperature. The unit
MED
HIGH