Deflection (16:9 Mode) Adjustment/Confirmation - Panasonic TX-29P800R-IRAN Service Manual

5.5.

Deflection (16:9 Mode) Adjustment/Confirmation

5.5.1. DATA SETTING (16:9)
1. Copy the adjusted data of 100i/4:3 mode to 100i/16:9 in the table. 1 (Except V-S-Correct)
2. Copy the adjusted data of 75i / 4:3 mode to 75i / 16:9 in the table 1 (Except V-S-Correct).
3. Copy the adjusted data of 50p(625p) / 4:3 mode to 50p(625p) / 16:9 in the table 1 (Except Except V-S-Correct)
4. Copy the adjusted data of 60p(525p,SD / 4:3 mode to 60p(525p,SD) / 16:9 in the table 1 (Except V-S-Correct)
5.5.2. V-CENTER, V-HEIGHT, V-LINEAR(16:9) ADJUSTMENT
1. Receive PAL monoscope pattern (E10) (UTF:E-5) (If no burst signal: Set to force PAL)
(Middle and south america model : Colour dac=0)
2. Set the aspect to 16:9 by remote control key.
3. Set scan mode to 100 Hz by remote key.
4. Adjust V-POS (100i/16:9) so that the scale of the top and bottomside is equal
5. Confirm that A, B in Fig. 22 is *1, if not, adjust V-AMP (AMP(100i/16:9)
*1
29" 5.0cm ± 1cm
34" 6.0cm ± 1cm
6. Confirm V-Linear (100i/16:9) as to the balance of circle.
If need, adjust V-Linear (100i/16:9)
7. Set scan mode to 75/8331 by remote control key.
8. Adjust and confirm as same above 4) - 6) by V-POS(75i/16:9), V-AMP(75i/16:9) and V-Linear(75i/16:9)
9. Set scan mode to progressive by remote control key.
10. Adjust and confirm as same above 4) - 6) by V-POS(50p(625p), V-AMP(50p(625p)/16:9) and V-Linear(50p(625p)/16:9)
11. Receive NTSC monoscope pattern (J11) (UTF:JA-9)
12. Adjust and confirm as same above 4) - 6) by V-POS(60p(525p,SD)/16:9, V-AMP(60p(525p,SD)/16:9) and V-
Linear(60p(525p,SD)/16:9). Set scan mode to Progressive by remote control key.
21
TX-29P800R-IRAN