Table of Contents
Advertisement
TX-29P800R-IRAN
5.6.
Deflection (16:9Mode) Adjustment/Confirmation
5.6.1.
100i SIDE PINCUSHION ADJUSTMENT (16:9 MODE)
1. Receive PAL croshatch pattern (E-5) (UTF:E-21)
(Middle and south America/Philippine model (UTF:E-4))
2. Set the aspect to 16:9 by remote control key.
3. Set scan mode to 100Hz by remote control key.
4. Adjust Trapezoid (100i / 16:9) and Parabola (100i / 16:9) to make straight vertical at both side.
5. Confirm there is no H-Parallel distortion.
In case of distortion is visible, adjust H-Parallel (100i/16:9) to make vertical line has no tilt at centre.
Repeat 4) so that there is no Trapezoid/H-Pararell distortion.
6. Confirm the vertical pincushion at top/bottom corner.
In case of distortion is visible, adjust Top-Corner (100i / 16:9) and/or bottom corner (100i / 16:9).
7. Confirm bow level at centre of vertical line.
If the vertical line at centre is curved, adjust C-Correct (100i / 16:9)and repeat from 4)
5.6.2.
75i SIDE PINCUSHION ADJUSTMENT (16:9 MODE)
1. Set scan mode to 75 / 8331 by remote control key.
2. Adjust Trapezoid (75i / 16:9) and Parabola (75i / 16:9) to make straight vertical line at both side.
3. Confirm there is no H-parallel distortion.
In case of distortion is visible, adjust H-Parallel (75i/16:9) to make vertical line has no tilt at centre.
Repeat 3) so that there is no Trapezoid/H-Pararell distortion.
4. Confirm the vertical pincushion at top/bottom corner.
In case of distortion is visible, adjust Top-Corner(75i / 16:9)
5. Confirm bow level at centre of vertical line.
If the vertical line at centre is curved, adjust C-Correct (75i / 16:9) and repeat from 3)
5.6.3.
50p SIDE PINCUSHION ADJUSTMENT (16:9 MODE)
1. Set scan mode to Progressive by remote control key.
2. Adjust Trapezoid (50p(625p)/16:9) and Parabola (50p(625p)/16:9) and Parabola (75i/16:9) to make straight vertical line at both
22
Advertisement
Table of Contents
