Table of Contents
Advertisement
2.3 Motherboard Installation
All motherboards have standard mounting holes to fit different types of chassis. Make sure
that the locations of all the mounting holes for both the motherboard and the chassis match.
Although a chassis may have both plastic and metal mounting fasteners, metal ones are
highly recommended because they ground the motherboard to the chassis. Make sure that
the metal standoffs click in or are screwed in tightly.
Tools Needed
Phillips
Screwdriver
(1)
MH2
JSPKR1
I-SATA0
MH4
Location of Mounting Holes
Note 1: To avoid damaging the motherboard and its components, do not use a force
greater than 8 lbf-in on each mounting screw during motherboard installation.
Note 2: Some components are very close to the mounting holes. Take precautionary
measures to avoid damaging these components when installing the motherboard to
the chassis.
Phillips Screws
PCB EDGE
LAN2
LAN1
JMD1
JGP1
JMD1_SRW1
JMD2_SRW1
JMD3_SRW1
X13SAV-PS
JMD3
REV:1.01
DESIGNED IN USA
JMD2
DIMMA1
DIMMB1
JL1
JPT1 JPME2
JD1
(4)
PCB EDGE
PCB EDGE
PCB EDGE
PCB EDGE
PCB EDGE
USB0
USB6/7
USB8/9
USB5 (3.2)
CPU
29
Chapter 2: Installation
Standoffs (4)
Only if Needed
PCB EDGE
HDMI2.0B
DP
MH1
FAN1
FAN2
EDP1
JPWR1
JPV1
MH3
Advertisement
Table of Contents
