ViewSonic N4290p User Manual page 12

2. Digital devices from different manufacturers have the possibility of differing output
standards which may cause difficulties for the television to properly display.
3. In case no signal is detected from your HDMI device, turn off the HDMI device and then
on again.
4. To get an optimal viewing, it is advised to turn your DVD player to one of the following
TV display standards:1280x720p@ 60hz
(7)VGA Signal Input:
Use the VGA signal cable to connect signals from a PC to the TV Input.
Connect the PC audio cable supplied with the TV to the TV's PC Audio Input.
Note: If no signal is present on the VGA screen, the TV will enter into standby mode
automatically after 60seconds.
ViewSonic 10 N3290w/N4290p/N4790p