Switching Input Signal - ViewSonic PJ513D User Manual

Switching input signal

The projector can be connected to multiple devices at the same time. However, it can
only display one full screen at a time.
Be sure the Quick Auto Search function in the SOURCE menu is On (which is the
default of this projector) if you want the projector to automatically search for the
signals.
You can also manually cycle through the
available input sources.
1. Press SOURCE on the projector or
remote control. A source selection bar
displays.
2. Press
selected and press MODE/ENTER on
the projector or Mode/enter on the
remote control.
Once detected, the selected source
information will display at the corner of
the screen for seconds. If there is
multiple equipment connected to the
projector, repeat steps 1-2 to search for
another signal.
• The brightness level of the projected
image will change accordingly when you switch between different input signals. Data
(graphic) "PC" presentations using mostly static images are generally brighter than
"Video" using mostly moving images (movies).
The input signal type effects the options available for the Preset Mode. See
preset mode" on page 22
• The native display resolution of this projector is in a 4:3 aspect ratio. For best display
picture results, you should select and use an input source which outputs at this
resolution. Any other resolutions will be scaled by the projector depending upon the
'aspect ratio' setting, which may cause some image distortion or loss of picture clarity.
See "Selecting the aspect ratio" on page 21
ViewSonic
/ until your desired signal is
for details.
for details.
18
D-Sub / Comp.
Video
S-Video
"Selecting a
PJ513D/PJ513DB