Husky HPRO27SLOCKERBL Use And Care Manual page 9

□
If desired, add the blank plate (E) to the outside of the Locker (A) using the 6 Phillips head screws to cover the power
outlet opening.
E
3
Attaching the EVA Spacers
Peel off the paper back from the 3 EVA Spacers (FF), and af x in the appropriate position toward the rear of the Locker A.
- If mounting to the LEFT side of the Workbench, then see Figure (3-1).
- If mounting to the RIGHT side of the Workbench, then see Figure (3-2).
Figure (3-1)
4
Attaching the Casters
□
Be sure the door is locked and lay the Locker (A) down.
Use packaging material to protect the nish.
□
Attach the swivel casters (B) to the outer side of the Locker (A),
by inserting 8 M8 Bolts (AA) and washers (BB) through the swivel
caster (B). Use the Hex Key (GG) to tighten the bolts to the
bottom frame.
Note: If assembling Locker (A) to the left side of the Workbench,
then casters will mount to the left side.
If assembling Locker (A) to the right side of the Workbench,
then casters will mount to the right side.
FF
9 Please contact 1-888-HD-HUSKY
E
Figure (3-2)
HUSKYTOOLS.COM
for further assistance.