□
Remove from the HPRO72MWC20BLK Workbench, the side handle, rubber grommet, 2 power cord storage hooks,
power outlet and holder.
□
Remove the Power outlet from the Workbench by removing the 6 Phillips head screws from the outlet panel cover and gently
pulling the Power outlet and the holder out of the cabinet. Be careful when pulling the cord through the grommet to avoid
pinching and damaging the cord. Once the cord plug head is pulled through, then remove the exterior rubber grommet on
the right side.
□
The right side of the workbench should be free of any obstructions to install the Locker (A).
□
If desired, the side handle can be relocated from the Workbench to the exterior wall of the Side Locker A using the existing
bolts after Step 6.
2
Power outlet orientation
□
The power outlet (C) can be installed on the left or right hand side of the Locker (A), either facing to the inside or
outside orientation.
C
A
C
8
Remove
A