Dyson DC22 Service Manual page 44

Service manual
87 Attach all cables to the satellite assembly (models with finger tip controls only).
Please note: when attaching cables to the satellite assembly it is possible to fit
two of the cables incorrectly. It is essential to ensure all cables are attached to
the correct connectors as shown below.
After fitting the motor and attaching the cables to the satellite assembly the following parts should be
fitted as previously shown:
Cable rewind assembly (pages 17-23).
41
Switch loom cable
Motor ribbon
cable
Cyclone inlet cable
(Motorhead products only)
(three wires)
PCB EMC cable
(two wires)