Table of Contents
Advertisement
The X-Over Switch position for a 4.2ch system
(frequency range is divided between highs for front/rear and
lows for the Subwoofer).
The position of the X-Over switch: F/R/Sub-W
Front high range
speaker (L)
Rear high range
speaker (L)
Low range
speaker (L)
Output of this unit:
• Use the Sub-W output cord to connect the unit to the low range speaker.
• You can use the built-in amplifier to output the front output/rear output.
• You cannot adjust the fader when set to 3WAY.
To prevent external noise from entering the audio system.
• Locate the unit and route the leads at least 10 cm away from the car harness.
• Keep the battery power leads as far away from other leads as possible.
• Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.
• If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various noise
suppressors, contact them for further information.
• Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
36
-EN
Front high range
speaker (R)
Rear high range
speaker (R)
Low range
speaker (R)
Front output
The X-Over Switch position for a 2.2ch system whose frequency
range is divided among the highs (Rear), mids (Front), and lows
(Subwoofer).
The position of the X-Over switch: 3WAY
Mid range
speaker (L)
High range
speaker (L)
Low range
speaker (L)
Rear output
Mid range
speaker (R)
High range
speaker (R)
Low range
speaker (R)
SUB-W output
Advertisement
Table of Contents
