Step 8.
Lift out the air duct cover.
Replacing a DIMM
To replace a DIMM, you must locate it in the controller module using the DIMM map label on top of the air
duct or locating it using the LED next to the DIMM, and then replace it following the specific sequence of
steps.
A A b b o o u u t t t t h h i i s s t t a a s s k k
A video for this task is available at:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-C8THdP1nmPF25RWwGRta3v
P P r r o o c c e e d d u u r r e e
Step 1.
Replace the impaired DIMM on your controller module.
The DIMMs are in slot 3 or 1 on the motherboard. Slot 2 and 4 are left empty. Do not attempt to
install DIMMs into these slots.
Note: The fault LED located on the board next to each DIMM blinks every two seconds.
.
Chapter 4
Hardware replacement procedures
45