Table of Contents
Advertisement
Step
Step 2.
To complete setting up your system, see "Completing system setup and configuration" on page 20.
Completing system setup and configuration
You can complete the system setup and configuration using cluster discovery with only a connection to the
switch and laptop, or by connecting directly to a controller in the system and then connecting to the
management switch.
Completing system setup using the console port
This section will describe how to complete the system setup using the console port for your system.
P P r r o o c c e e d d u u r r e e
Step 1.
Cable and configure your laptop or console:
a.
Set the console port on the laptop or console to 115,200 baud with N-8-1.
Note: See your laptop or console's online help for how to configure the console port.
b.
Connect the console cable to the laptop or console using the console cable that came with
your system, and then connect the laptop to the management switch on the management
subnet .
ThinkSystem DM5100F Hardware Installation and Maintenance Guide
20
Perform on each controller module
Cable controller A to the shelf
Cable controller B to the shelf:
Advertisement
Table of Contents
