Table of Contents
Advertisement
2 2
Getting Started
A. Design and Installation Considerations
Installation MUST comply with local, regional, state and
national codes and regulations. Consult insurance carrier,
local building inspector, fire officials or authorities having
jurisdiction over restrictions, installation inspection and
permits.
Before installing, determine the following:
•
Where burner assembly and log set are to be installed.
•
Gas supply piping.
•
Whether optional accessories—devices such as a wall
switch or remote control—are desired.
•
Approved wood burning masonry fireplace or vent-free
fireplace.
The Lumonessen outdoor series gas appliance is de-
signed for outdoor use and may be installed as a stand
alone appliance or built into a wall.
Outdoor spaces - For the purpose of these instructions,
an appliance is considered to be outdoors if installed with
shelter no more inclusive than:
1. With walls on all sides, but no overhead cover
2. Within a partial enclosure which includes an over-
head cover and no more than two side walls. These
side walls may be parallel, as in a breezeway, or at
right angles to each other; or
3. Within a partial enclosure which includes an over-
head cover and three sidewalls, as long as 30 % or
more of the horizontal periphery of the enclosure is
permanently open.
NOTE: Screen may be used on the open sides of the
shelter. 14x18 and 16x18 screen mesh is approved for
use. DO NOT use solar screen or no-see-um screen.
NOTE: See page 6 for additional information on appli-
ance location requirements for outdoor living spaces.
The appliance may be installed on a wood or non-com-
bustible deck.
Refer to section three for clearances.
Installation MUST comply with local, regional, state and
national codes and regulations. Consult the authorities
having jurisdiction over restrictions, installation inspection
and permits.
Outdoor Lifestyles • Lumonessen Owner's /Installation Manual • 4629-900 Rev. A • 02/23
Before installing, determine the following:
•
Where the appliance is to be installed.
–
Clearances to side walls.
–
Location of indoor appliance terminations, air in-
lets, gas meters, etc.
–
Location of the appliance to a door that swings
open to ensure it doesn't interfere with the appli-
ance when opened
–
Location of Windows.
–
Location of Walkways.
–
Possibility of flooding or running water.
•
Gas supply piping requirements.
•
Electrical wiring requirements.
•
Framing and finishing details.
Installation and service of this appliance should
be performed by qualified personnel. Hearth
& Home Technologies recommends HHT
Factory Trained or NFI certified professionals.
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage. For
assistance or additional information, consult a qualified
service technician, service agency or your dealer.
B. Tools and Supplies Needed
Before beginning the installation be sure that the following
tools and building supplies are available.
•
Tape measure
•
Gloves
•
Voltmeter
•
Manometer
•
Phillips screwdriver
•
Safety glasses
•
Flat blade screwdriver
•
Soapy water solution for gas leak testing
•
Electric drill and bits (1/4 in. magnetic)
•
External regulator (for propane/LPG only & 1/2 psi
Natural gas system)
•
Piping which complies with local codes
•
Pipe sealant approved for use with propane/LPG
(Resistant to sulfur compounds)
Gloves are recommended when handling
refractory and logs to prevent skin irritation
from loose fibers. Logs are fragile; handle
with care.
•
Manual shutoff valve
•
Sediment trap
•
Tee joint
•
Pipe wrench
5
Advertisement
Table of Contents
