Table of Contents
Advertisement
ADT-CHG-120 Instruction 05/01/98 PN 50938:A
This section contains instructions and illustrations for installing the charger, divided into
the following topics:
Section
Installation Precautions and
Standards
Charger Connections,
Jumpers, and Switches
Connecting AC Power to
the Charger
Connecting Batteries to the
Charger
Mounting the Charger
Connecting the Charger to
a Load
Configuring the Charger
Trouble and Form-C Relay
Connections (Optional)
Installing Optional Meters
%DWWHU\ 3UHFDXWLRQV
When installing the charger, observe the following precautions:
V
Observe polarity when making connections.
V
Do not connect the Battery Interconnect Cable until instructed.
V
Batteries, although sealed, contain hazardous acid chemicals.
V
Charging batteries can cause flammable hydrogen gas.
V
Take care when handling batteries: batteries are heavy—take care in lifting and
handling them.
V
Mounting batteries requires proper mounting hardware. Follow the battery
manufacture's installation instructions
Topic(s) Covered
Precautions to take when installing the charger
and recommended installation standards.
Location and references to connections,
jumpers, and switches used to configure,
maintain, and operate the charger.
How to connect AC power to the charger.
How to connect batteries to the charger in two
configurations: using two batteries and using
four batteries.
How to mount the charger to a CAB-3.
How to mount the charger to a BB-55.
Instructions and illustrations for wiring a charger
to a multiple load and for wiring a charger for a
large system installation.
Configuring the charger for the following
options:
Delaying loss of AC reporting (DACT); and
Disabling ground fault detection
Instructions and illustrations for connecting the
following:
Open Collector Trouble In (JP5)
Trouble Out (JP4)
Master Trouble In (JP6)
Form-C Trouble Relay (TB3)
How to install an optional ammeter, voltmeter,
or both.
Table 2 Installation Topics
Page
3
4
5
6
8
10
12
13
14
3
Advertisement
Table of Contents
