ADT -CHG-120 Instruction Manual page 11

,QVWDOOLQJ WKH &KDUJHU
8
0RXQWLQJ WKH &KDUJHU LQWR D &$% 6HULHV &DELQHW
bottom row of a CAB-3 Series Cabinet, as long as the charger is within 20 feet of the load.
Typically, a charger mounts into the lower right corner of the CAB-3—beside the power
supply (Figure 7, position 2). If using an additional CAB-3, you can mount the charger in
the lower left corner (Figure 7, position 2). Figure 7 shows the two mounting positions of a
charger into a CAB-3.
Position 1: Lower right corner.
Figure 7 Mounting a Charger into a CAB-3 Series Cabinet (CAB-C3 shown)
To mount a charger into a CAB-3 Series Cabinet, follow these instructions:
Step Action
1 Place the charger chassis mounting slots in line with the mounting holes in the cabinet. If
mounting in position 2, place the charger chassis onto the mounting hooks in the cabinet.
2 Insert the self-tapping screws through the charger chassis mounting slots and into the
mounting holes in the cabinet.
6HOIWDSSLQJ VFUHZ
3 Tighten the self-tapping screws.
Mounting the Charger
You can mount a charger into the
0RXQWLQJ
KRRNV
Position 2: Lower left corner.
&KDVVLV PRXQWLQJ
VORW
ADT-CHG-120 Instruction 05/01/98 PN 50938:A