ADT -CHG-120 Instruction Manual page 10

Connecting Batteries to the Charger
Warning: Do not
connect the Battery
Interconnect Cable
at this time.
Refer to "Starting the
Charger" on page 16.
ADT-CHG-120 Instruction 05/01/98 PN 50938:A
&RQQHFWLQJ )RXU %DWWHULHV
charger:
%
Figure 6 Connecting Four Batteries to a Charger
Table 4 contains instructions for connecting four batteries to the charger:
Step Action
1 Remove all power sources to the charger.
2 Tie the batteries in pairs by connecting the battery negative terminals and the
battery positive terminals as shown in Figure 6.
3 Connect the battery negative cable to the TB2 terminal (on the charger labeled
"Battery –") as shown in Figure 6.
4 Connect the battery positive cable to the TB2 terminal (on the charger) labeled
"Battery +") as shown in Figure 6.
5 Proceed to the section "Connecting the Charger." Do not connect the Battery
Interconnect Cable at this time—refer to "Starting the Charger" on page 16.
Figure 6 shows how to connect four 55 AH batteries to the
036
Table 4 Connecting 55 AH Batteries
,QVWDOOLQJ WKH &KDUJHU
7%
$'7&+*
7