Table of Contents
Advertisement
Appendix
Equalizer
This is a three-band equalizer.
Parameter
-15–15 (dB)
LOW GAIN
-15–15 (dB)
MID GAIN
-15–15 (dB)
HIGH GAIN
LOW FREQ
20, 25, 31, 40, 50, 63, 80, 100, 125, 160, 200, 250, 315, 400 (Hz)
200, 250, 315, 400, 500, 630, 800, 1000, 1250, 1600, 2000, 2500,
Mid Freq
3150, 4000, 5000, 6300, 8000 (Hz)
2000, 2500, 3150, 4000, 5000, 6300, 8000, 10000, 12500, 16000
HIGH FREQ
(Hz)
Compressor
This effect reduces high volume levels while bringing up the level of quieter sounds, smoothing out any variations in overall
volume.
Parameter
Value
SUSTAIN
0–100
ATTACK
0–100
RATIO
0–100
LEVEL
0–100
This effect may output a very loud sound, depending on how the parameters are set. Use caution not to raise the values too
much.
SX Reverb
This adds reverberation to the sound.
As with the SP-404SX, you can adjust the volume balance between the dry (original) sound and the effect sound with this effect.
Parameter
Value
TIME
0–100
TONE
-12–+12
BALANCE
100-0–0-100 (%)
SX Delay
Gives an echo effect in sync with the tempo.
As with the SP-404SX, you can adjust the volume balance between the dry (original) sound and the effect sound with this effect.
Parameter
1/32, 1/16T, 1/32D, 1/16, 1/8T, 1/16D, 1/8, 1/4T, 1/8D,
TIME
1/4, 1/2T, 1/4D, 1/2, 1/1T, 1/2D, 1/1
FEEDBACK
0–99 (%)
100-0–0-100 (%)
BALANCE
Cloud Delay
Adds multiple delays to the dry sound, as well as reverberations for a thick "cloudy" effect.
Parameter
Value
0–100
WINDOW
138
Value
Sets how long the effect is applied to the decaying sound.
Sets how long it takes to reduce the volume when a high input level is detected.
Sets the compression ratio.
Adjusts the volume of the effect sound.
Sets the reverb time.
Adjusts the tonal character of the reverb.
Adjusts the volume balance between the dry (original) sound and effect sound.
Value
Adjusts the interval for the delayed sound.
Larger settings produce a deeper reverberation.
Explanation
Adjusts the amount of boost/cut of the low-
frequency range.
Adjusts the amount of boost/cut of the
mid-frequency range.
Adjusts the amount of boost/cut of the
high-frequency range.
Sets the low-frequency range.
Sets the mid-frequency range.
Sets the high-frequency range.
Explanation
Explanation
Explanation
Sets the sound delay time.
Adjusts the amount of feedback for the effect.
Adjusts the volume balance between the dry
(original) sound and effect sound.
Explanation
Advertisement
Table of Contents
