Installation; Inspecting The Equipment; Pdm Setup - Powerware 9125 User Manual

C H A P T E R 2
I
NSTALLATION
This section explains:
: Equipment inspection
: Rack-mount and tower setup
: Low-voltage and high-voltage installation
: PowerPass Distribution Module rear panels
: Load segments

Inspecting the Equipment

If any equipment has been damaged during shipment, keep the shipping
cartons and packing materials for the carrier or place of purchase and
file a claim for shipping damage. If you discover damage after
acceptance, file a claim for concealed damage.
To file a claim for shipping damage or concealed damage: 1) File with
the carrier within 15 days of receipt of the equipment; 2) Send a copy of
the damage claim within 15 days to your service representative.

PDM Setup

NOTE If you are installing the UPS for the first time, follow the instructions in the
UPS user's guide to set up the UPS and any optional Extended Battery Modules
(EBMs). Do not connect your equipment to the UPS or start up the UPS before
installing the PDM.
If the UPS is already installed and operating, prepare your equipment for
shutdown and use the following procedure to shut down the UPS:
1. Turn off the equipment that is connected to the UPS.
2. Press and hold the Off
Powerware 9125 (2500–3000 VA) PowerPass
®
seconds. The UPS switches to Standby mode and removes
power from the UPS output receptacles.
Distribution Module User's Guide
®
button for approximately three
:
164201392 Rev B www.powerware.com
13