Replacing The Reel Enable Fuse; Replacing The Main Power Fuse - Toro Reelmaster 5010-H Operator's Manual

Figure 105
1. Cover
2. Maxi fuse
4. Replace the open fuse with a fuse of the same
type and amperage rating.
Note:
Refer to the decal on the cover.
Figure 106
5. Assemble the cover to the 48 V fuse-block.
g379036
3. 48 V fuse block
g379037
6. Close and latch the hood; refer to
Hood (page 49).
Replacing the Reel Enable
Fuse
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Unlatch and open the hood; refer to
Hood (page 49).
3. At the front, right side of the engine, remove the
cap from the in-line fuse holder labeled E
F 10 A 125 V.
USE
1. Fuse holder (labeledE
4. Replace the open fuse with a fuse of the same
type and amperage rating.
5. Install the cap on the in-line fuse holder.
6. Close and latch the hood; refer to
Hood (page 49).
Replacing the Main Power
Fuse
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page
2. Unlatch and open the hood; refer to
Hood (page 49).
3. At the rear, right side of the engine, remove the
cover of the in-line fuse holder labeled Main B+
Power Fuse.
66
Closing the
49).
Opening the
Figure 107
F 10 A 125 V)
NABLE USE
Closing the
49).
Opening the
NABLE
g421600