Starting Warm Engine - Echo SRM-225 Operator's Manual

SRM-225
5. Choke
After engine fires (or five pulls), move choke (B) to the RUN (
handle and throttle trigger lockout with left hand and fully depress throttle trigger to wide open position. Pull
starter handle/rope until engine starts and runs. Release throttle trigger and allow unit to warm up at idle for
several minutes.
Note: If engine does not start with choke in "RUN" position after five pulls, repeat instructions 2 - 5.
6. Throttle Trigger
After engine warm-up, grip throttle handle and support handle. Depress the throttle trigger lockout, and
gradually depress throttle trigger to increase engine RPM to operating speed.

Starting Warm Engine

The starting procedure is the same as Cold Start except DO NOT close the choke, and do not hold throttle
trigger fully depressed.
The attachment should not move at idle, otherwise serious personal injury may result.
Note: If attachment moves, readjust carburetor according to "Carburetor Adjustment" instructions in this
manual or see your ECHO Dealer.
1. Stop Switch
Move stop switch button (A) forward away from the STOP
position.
2. Purge Bulb
Pump purge bulb (C) until fuel is visible in the "Clear" fuel
return line. Pump bulb an additional four or five times.
X7732278503
© 01/22 ECHO Incorporated
) (open) position. Firmly grasp throttle
A
B
OPERATION
C
17