Air Filter; Fuel Filter - Echo SRM-225 Operator's Manual

SRM-225

Air Filter

Level 1.
Parts required: Tune-Up Kit.
1. Close choke (COLD START [
dirt from entering the carburetor throat when the air filter is
removed. Brush accumulated dirt from air cleaner area.
2. Remove air filter cover. Brush dirt from inside cover.
3. Replace filter if it is damaged, fuel soaked, very dirty, or the
rubber sealing edges are deformed.
• Lightly brush debris from filter.
• Soak heavily soiled filters in water/detergent solution to
loosen dirt, then brush lightly.
• Rinse with clean water and allow to dry completely before reuse.
4. Install air filter in air filter case.
5. Install air filter cover.

Fuel Filter

Level 1.
Parts required: Tune-Up Kit.
Fuel is VERY flammable. Use extreme care when mixing, storing or handling, or serious personal
injury may result.
1. Use a clean rag to remove loose dirt from around fuel cap
and empty fuel tank.
2. Pull the fuel filter from the fuel tank.
3. Remove the filter from the line and install the new filter.
Note: Federal EPA regulations require all model year 2012 and
later gasoline powered engines produced for sale in the
United States to be equipped with a special low
permeation fuel supply hose between the carburetor and
fuel tank. When servicing model year 2012 and later
equipment, only fuel supply hoses certified by EPA can
be used to replace the original equipment supply hose.
Fines up to $37,500 may be enforced for using an
un-certified replacement part.
X7732278503
© 01/22 ECHO Incorporated
] position). This prevents
MAINTENANCE
23