Troubleshooting - Nikon Nuvis 200 Instruction Manual

Troubleshooting

Check the cause of the trouble using the following chart. It may save you a trip to your nearest Nikon service center.
E Problem
The shutter cannot be
released.
The flash does not fire.
The subject appears out of
focus in the print.
28
•If the red LED blinks when the shutter release button is pressed lightly, the flash is being charged
and the shutter is locked. Remove your finger from the shutter release button, lightly press the
shutter release button again and wait for the red LED to light up before reshooting.
•If the letter ´ and the cartridge indicator
usable. Replace the film with a new cartridge.
•If the red LED blinks when the shutter release button is pressed lightly, the flash is being charged
and the shutter is locked. Remove your finger from the shutter release button, lightly press the
shutter release button again and wait for the red LED to light up before reshooting.
•Check battery power. If the battery is exhausted, replace the battery with a fresh one.
#
" "
•If the mark appears on the LCD panel, the flash will not fire.
•Clean the autofocus windows if dirty.
•To avoid camera shake, gently depress the shutter release button.
•When photographing difficult-to-focus subjects, be sure to center the autofocus frame mark on
the subject, or use focus lock.
Check this
" " appear on the LCD panel, the film loaded is not
Ref. page
14, 21
10, 18
14, 21
9
21
6
13
17, 20