Table of Contents
Advertisement
en Installation instructions
Tools
Contact technical customer service to purchase the rel-
evant tools.
Removal lever
Removing the upper part of the appliance (glass
plate with cut-out profiles)
Remove the pan supports, burner caps, distributors
1.
and rotary knobs.
Undo the screws on the burners.
2.
Move the removal lever under the metal cut-out pro-
3.
file into the area marked for the cooktop model and
loosen the front clip fastener.
Only use the lever under the cut-out profiles or the
metal frame of the cooktop.
Carefully lift the glass plate with the cut-out profiles
4.
to release the rear clip fastener.
Removing the circuit board
Tip: The circuit board is secured to the holder by
fastening pins at the sides and in the middle. Push the
fastening pins carefully without damaging them. If one
of the pins breaks, the entire holder must be replaced.
Injectors
Request change-over injectors from our customer service deparment. Refer injector chart below for sizes.
Burner
Dual-wok multi-crown
burner
10
483196
NG
Hourly gas consump-
tion (MJ)
22.00
ATTENTION!
The circuit board can be damaged by improper hand-
ling.
Handle the circuit board carefully.
▶
Use anti-static shields or hold the circuit board at
▶
the edges.
Never touch the surfaces of the circuit board on
▶
which there are components or conducting tracks.
Undo the fastening pins on one side.
1.
Release the fastening pins in the middle by pressing
2.
on them from both sides with your fingers.
Undo the fastening pins on the other side and re-
3.
move the circuit board.
Adjusting the taps
Requirement: The upper part of the appliance and the
circuit board are removed.
→ "Removing the upper part of the appliance (glass
plate with cut-out profiles)", Page 10
→ "Removing the circuit board", Page 10
Remove the cylindrical parts and springs from the
1.
fittings spindle.
Adjust the bypass screws:
2.
A: For ULPG, the bypass screws must be
‒
tightened properly.
B: For Natural Gas, the bypass screws must fin-
‒
ish flush with the fitting.
NG
Injector mark
¡ Outer flame: 215
Z= 11
¡ Inner flame: 65
ULPG
Hourly gas consump-
tion (MJ)
19.00
ULPG
Injector mark
¡ Outer flame: 115
Z= 11
¡ Inner flame: 47
Advertisement
Table of Contents
