Table of Contents
Advertisement
CONNECTION
Connect the Device Expansion Unit to the NEC Express server through the SAS interface
cable (K410-168(02)/K410-191(02)).
The SAS connector enabling the Device Expansion Unit to be connected to the NEC
Express Server is provided on the rear of the Device Expansion Unit. Turn off the power of
the NEC Express server, pull out the power plug of the server from the AC outlet, and
connect the SAS cable to the server. After connecting the Device Expansion Unit to the
NEC Express server through the SAS interface cable, insert the power plug of the NEC
Express server and that of the Device Expansion Unit into AC outlets.
Always observe the following cautions to enable you to use the Device
Expansion Unit safely.
Failure to follow these instructions may cause death or serious personal injury.
See the description on pages vi through xvii for details.
Always observe the following cautions to enable you to use the Device
Expansion Unit safely.
Failure to follow these cautions may cause personal injury including burns
and/or physical damages. See the description on pages vi through xvii for
details.
interface cable.
Do not hold the power plug with wet hands.
Do not connect the ground wire to a gas pipe.
Plug into a proper power source.
Do not connect many cords into a single outlet by using extension cords.
Insert the power plug into the outlet as far as it goes.
Do not use a power cord other than the specified.
Always pull out the power plug before connecting or disconnecting the
Do not use any interface cables that are not authorized by NEC.
WARNING
CAUTION
- 20 -
Advertisement
Table of Contents
