Panasonic AJ-D455 Operating Instructions Manual page 47

Warning
Priority Error No. TV monitor display*
E-10* FAN STOP
High
(Err-10)
NO RF
E-09*
(Err-09)
SERVO NOT LOCKED Error No. lights when servo disturbances continue for
E-00*
(Err-00)
LOW RF
E-01*
(Err-01)
HIGH ERROR RATE
E-02*
(Err-02)
Low
* Displays when warning information is checked by pressing the DIAG button.
AUTO OFF mode
The following error number flashes on the counter display section.
Error No. TV monitor display
E-20
DEW
Any other
number
Description
Error No. lights when a fan motor stops operating.
This appears when a blank exceeding 1 second is
detected on the tape during playback.
3 or more seconds during playback, recording or
editing.
Error No. lights when envelope levels approx. 1/3 that
of normal levels are detected for more than 1 sec.
during playback, recording or editing.
Error No. lights when the error rate increases and
correction/interpolation is performed on either the
video or audio playback signal.
Descriptions
When condensation is detected, the error no. display
flashes, and the unit goes into EJECT mode. The drum
rotates after the cassette tape is ejected to remove
condensation.
When the condensation has been removed, the error no.
display disappears and the VTR may be used.
<Notes>
1) The drum rotates as soon as condensation is detected
when the unit is in EJECT mode.
2) When condensation is detected while a cassette tape is
inserted, drum rotation stops, the cassette tape is ejected
and the drum rotation begins again.
If any other number appears frequently, ask your dealer to
inspect the unit.
47
VTR operation
Continued
Continued
Continued
Continued
Continued
VTR operation
(VTR measures)
EJECT