Installing The Optional Motion Detector Board - Panasonic WJ-HD500A Operating Instructions Manual

Installing the Optional Motion
Detector Board
The Motion Detector Board WJ-HDB501 is installed exclu-
sively in the WJ-HD500A Disk Recorder.
1. Unplug the power cord from the WJ-HD500A Digital
Disk Recorder, or disconnect the plug from the AC out-
let.
2. Remove the top cover of the Disk Recorder by remov-
ing the 11 screws, as shown below.
Disk Recorder
WJ-HD500A
3. Remove the 6 screws on the board, as shown below,
and disconnect the CN403.
4. Turn over the Main Board with the front side up.
Main Board
13
CN403
5. Place the Motion Detector Board on the Analog Board,
as shown below, and plug in the boards.
6. Fix both boards with the 3 supplied screws, as shown
below.
Main Board
Motion Detector
Board
CN601
CN501
Analog Board
7. After installing the board, connect CN403 and the main
board, then secure them by tightening the screws
shown below.
CN101
CN502
CN403