I Connections With The Vtr - Panasonic WJ-HD309 Operating Instructions Manual

I Connections with the VTR

When it is necessary to copy the recorded images to a video tape using a VTR, connect the VTR to the S-VIDEO connector (or
the VIDEO OUT connector) and the AUDIO OUT connector inside the connectors cover on the front panel of this unit as below.
TIMER
ERROR
ALARM
ALARM
ALARM
SUSPEND
RESET
HDD 1
OPERATE
HDD 2
Note: The same video signal supplied to the MONITOR1 connector and to the MONITOR2 (VGA) connector will be supplied to
the S-VIDEO connector and the VIDEO OUT connector inside the connectors cover.
The same audio signal supplied to the AUDIO OUT connector on the rear panel of this unit will be supplied to the AUDIO
OUT connector inside the connectors cover on the front panel.
STOP
MONITOR1
MONITOR2
1 2 3 4
PAN/ GOTO
TILT LAST
SHIFT SEQ OSD
5 6 7 8
ZOOM/ A-B
FOCUS
REPEAT
DISK SELECT COPY TEXT MARK
9 10/0 11 12 IRIS
LISTED
PRESET
EL-ZOOM LOGOUT LOGOUT
/AUTO
13 14 15 16
AUDIO
IN
VTR
VIDEO
IN
S-VIDEO IN
connector
Open the connectors cover.
PLAY PAUSE REC - REC STOP
REV FWD
SEARCH
SETUP
PAN/TILT
/ESC
SLOW
–
+
SET
BUSY
Audio cable with an RCA pin plug (Locally procured)
Audio cable with an RCA pin plug (Locally procured)
S-video cable (Locally procured)
S-VIDEO
COPY 2 VIDEO
OUT
AUDIO
OUT
73