Connections; I Connections When The Unit Is Used Independently - Panasonic WJ-HD309 Operating Instructions Manual
Digital disk recorders
Hide thumbs
Also See for WJ-HD309:
- Operating instructions manual (164 pages) ,
- Setup instructions (101 pages) ,
- Network operating instructions (72 pages)
Table of Contents
Advertisement
CONNECTIONS
Important
When connecting the Panasonic matrix switcher or the data multiplex unit to this unit, the looped through output signal for
every video input signal from them must be supplied to the video input connectors of this unit directly.
Do not supply the monitor output signal or the spot output signal from the matrix switcher or the data multiplex unit to the video
input connectors of this unit.
Otherwise, the images may be disorderly displayed and recorded for a split second. (The images displayed before switching
channel may be displayed and recorded.)
I Connections when the unit is used independently
An example of connections is shown below when the unit is used independently.
Important:
• The power plug should be connected last.
• When connecting combination cameras, connect them to the video input connectors 1 - 8 when using the WJ-HD316 or 1 -
6 when using the WJ-HD309 (for coaxial communication).
G Examples of connections
Microphone
Notes:
• The SETUP MENU will be displayed on monitor 2 and the VGA monitor. (It is impossible to display the SETUP MENU on
monitor 1.)
• The same images displayed on monitor 2 will be displayed on the VGA monitor.
• Depending on the connected monitor, flickering may occur when displaying the SETUP MENU. In this case, it is rec-
ommended to use the VGA monitor or a dirtectly connected PC using a LAN cable to perform the settings. (Refer to the
Network Setup Instructions (PDF) for descriptions of how to connect this unit and a PC directly.)
70
Monitor 1
Amplifier
1
3
1
SERIAL
CASCADE
4
2
OUT
2
AUDIO IN
AUDIO OUT
MONITOR OUT CASCADE IN
MONITOR (VGA)
16
15
14
13
12
11
IN
OUT
16
15
14
13
12
11
For Audio Amplifier
•
•
•
•
•
•
System cameras
(VIDEO IN 9 - 16)
Monitor 2
Mode switch setting (Factory default)
ON
Note: If the DATA and RS485 ports are not
used, the mode switches should be used as
illustrated.
MODE
ALARM
2
1
ALARM/CONTOROL
DATA
RS485(CAMERA)
10
9
8
7
6
5
4
10
9
8
7
6
5
4
VIDEO
•
•
•
•
•
Combination cameras
(VIDEO IN 1 - 8)
1 2 3 4 5
6 7 8
SIGNAL GND
COPY 1
10/100BASE-T
EXT STORAGE
3
2
1
3
2
1
120 V AC
50 Hz
•
POWER
AC IN
Advertisement
Table of Contents
