Table of Contents
Advertisement
72
EN
8 O.S.D.
ON
OFF
8 DIRECT REC
ON
OFF
8 AUTO SP]LP TIMER
ON
OFF
When this function is set to "ON", various operational indicators appear on
the TV screen. Messages appear in the selected language. (
NOTES:
● When you use this unit as the source player for editing, be sure to set "O.S.D." to
"OFF" before starting.
● During playback, the operation mode indicators may be disturbed depending on the
type of tape being used.
When this function is set to "ON", you can easily start recording the
programme that you are watching on your TV. Press and hold 7 and press 4
on the remote control, or press 7 on the unit.
NOTES:
● When you use the Direct Rec function, be sure to use a TV offering T-V LINK, etc.
and connect a fully-wired 21-pin SCART cable between the unit and the TV.
(
pg. 12)
● If "DIRECT REC" is set to "OFF", the 7 button functions as described in "Basic
Recording" (
pg. 26).
● During the Direct Rec, "– –" appears on the front display panel.
● When "DIRECT REC" is set to "ON", if you press any button just after pressing 7 on
the unit (or 7 and 4 on the remote control), the unit may not function properly.
When this function is set to "ON", the unit automatically switches to LP
mode to allow complete recording if there is not enough tape to record the
entire programme while timer-recording in SP mode.
For Example:
Recording a programme of 210 minutes in length onto a 180-minute tape
Approximately 150 minutes
SP mode
Total 210 minutes
Make sure you set this function to "ON", before the timer-recording starts.
NOTES:
● If you have programmed the unit to timer-record 2 or more programmes, the second
programme and those thereafter may not fit on the tape if you set "AUTO SP]LP
TIMER" to "ON". In this case, make sure the mode is not engaged, then set the tape
speed manually during timer programming.
● In order to ensure that the recording fits on the tape, this feature may leave a slight
non-recorded section at the end of the tape.
● There may be some noise and sound disturbance at the point on the tape where the
unit switches from SP to LP mode.
]
● The Auto SP
LP Timer feature is not available during ITR (Instant Timer Recording),
and the feature will not work properly with any tapes longer than E-180, or with
some tapes of shorter lengths.
● If you perform timer recording with both VPS/PDC and the Auto SP
activated, and the programme goes beyond its originally scheduled length, there
may be times when the programme cannot be recorded in its entirety.
SUBSIDIARY SETTINGS (cont.)
* The default setting is bold in the table below.
Approximately 60 minutes
LP mode
pg. 14, 18)
]
LP Timer
Advertisement
Table of Contents
