Drive Head And Decoupling Spring, Removing And Installing - Audi Q7 2007 Repair Manual

6-Cylinder Direct Injection 3.0L 4V TFSI Supercharged Engine - Edition 01.2016
1 - Bolt
❑ 27 Nm
❑ Always replace
❑ Self-locking
❑ Always clean the
threaded holes with a
thread tap before as‐
sembling
2 - Drive Head
❑ Removing and in‐
stalling. Refer to
"1.10 Drive Head and
Decoupling Spring, Re‐
moving and Installing",
page 243 .
3 - Decoupling Spring
❑ Removing and in‐
stalling. Refer to
"1.10 Drive Head and
Decoupling Spring, Re‐
moving and Installing",
page 243
4 - Supercharger Housing
1.10 Drive Head and Decoupling Spring, Re‐
moving and Installing
Special tools and workshop equipment required
♦ Used Oil Collection and Extraction Unit - SMN372500-
♦ Sealant. Refer to the Parts Catalog
♦ Oil for the supercharger drive. Refer to the Parts Catalog.
♦ Expanding pliers (commercially available)
Removing
• Supercharger is secured to the Engine And Transmission
Holder - VAS6095- . Refer to
to Engine/Transmission Holder", page 237
– Remove the coolant pipes from the supercharger. Refer to
"3.10 Supercharger Coolant Pipes, Removing and Installing",
page 209 .
– Hold the supercharger perpendicular on the engine/transmis‐
sion holder.
• The drive head faces up.
⇒
⇒
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
⇒ "1.6 Supercharger, Securing
.
Audi Q7 2007 ➤
⇒
243
1. Supercharger