Table of Contents
Advertisement
REFERENCE
Controls and Buttons
This part of the Reference sections discusses the controls and
buttons located on the receiver and the remote control.
Slide open the door to get to the Access Card.
Front Panel Controls
POWER Turns the satellite receiver's power on or put
the unit into standby mode.
RECALL Brings up the on-screen channel marker.
TV/DSS Switches the source of the video signal from
DSS
®
satellite signals to an off-air antenna or cable signal
(if you are using RF output from the satellite receiver).
ARROWS Press the navigation arrows to move the
on-screen highlight up, down, left, or right. Using the
arrows to highlight a menu item is also called "pointing."
MENU/SELECT Brings up the Main Menu. If you are
already in the menu system (or a program guide), press
MENU/SELECT to select a highlighted choice.
ACCESS CARD
providers. The DSS
40
Identifies you to your program
®
system requires a valid access card.
POWER
RECALL
MENU
SELECT
TV/DSS
Advertisement
Table of Contents
