Panasonic KX-P8415 Setup And Reference Manual page 27

Trouble
A piece of the printed image is
missing and reappears out of
place, approximately 129 mm (5 )
down the page.
Media frequently wraps around
the fuser unit.
The entire page prints in black,
including the borders.
The back of the printed page
appears dirty.
Solid color print for green, red and
blue are not printed out evenly in
the Adjustment to Media test
pattern.
Black, magenta and cyan halftone
have weak color area.
Service Error is displayed on the
LCD.
*
1 To see the sample in full color, see "Care and Maintenance" of the Operating Instructions installed on your
computer.
Possible Cause
The fuser unit's internal roller is
not being consistently oiled.
or
The fuser unit's internal roller is
contaminated with toner
particles.
The oil supply roll has reached
the end of its useful life.
Bad electrical contact for the
Charge unit.
The charge unit is broken.
The cleaning pad may get dirty
with toner.
Unrecommended media is used.
* 1
* 1
An error occurred that is not user-
correctable.
Corrective Action
Print 5-10 pages of blank pages to
clean the roller.
If you still see the problem:
BReplace the oil supply roll.
If you still see the problem:
BReplace the fuser unit.
Replace the oil supply roll.
Remove and reinsert the charge
unit.
Reinsert the color imaging unit to
correct the contact for the charge
unit.
Replace the charge unit.
Replace the cleaning pad.
Adjust the Adjustment to Media
value using the Printer panel. (See
"Adjusting the Adjustment to Media
Setting" in the "Settings and
Printing" installed on your
computer).
Use the recommended media
(see page 18).
Turn the printer off and back on
again. If the error persists, call for
service.
27