Connecting The Printer To A Computer; Loading Media In The Media Tray - Panasonic KX-P8415 Setup And Reference Manual

Connecting the Printer to a
Computer
If you do not have a parallel interface cable, you will
need to purchase one (see below) from your local
computer store or dealer. For detailed information,
see page 31 in the Reference Guide.
Connector Type IEEE 1284-B type connector
Use a shielded cable 2.0 m
Cable
(6.6 ft) or less in length.
1
Make sure the computer, printer and
the other connected peripheral
devices are turned off.
2
Connect the parallel interface cable to
the computer's parallel interface
connector and the printer's one.
Computer's
parallel interface
connector
Notes:
BThe actual connector on the computer may
differ depending on the manufacturer of the
computer.
BIf the cable is connected to the PC via a printer
buffer or selector, the printer may not print.
3
Connect the power cord to the
printer's AC inlet and to an AC outlet.
Loading Media in the Media
Tray
The printer is shipped with a media tray (Letter
paper or A4 paper) installed. Besides them,
transparency or legal paper tray can be used.To use
these media trays, see page 18 on the Reference
Guide or "Settings and Printing" on the KX-P8415
CD-ROM.
Available media:
Media Thickness
Laser paper *
1
B&W: 60 to 105 g/m
Color: 75 to 105 g/m
* Recommended paper is as follows:
1
Letter/Legal: Hammermill LASERPRINT 90 g /m
(24 lbs.)
A4: 4CC 80 g /m
2
Caution:
BDo not use a media for ink jet that may be
wrapped around the fuser roller and cause
damage.
1
Pull the media tray out of the printer.
Remove all packing materials from
2
inside the media tray; refer to the
instruction sheet attached to the tray.
2
(16 to 28 lbs.)
2
(20 to 28 lbs.)
2
11