MB2198 – Getting Started
Chapter 3 Starting Debugging
3.2 Executing the Program
Now choose Debug > Run > Go, press F5 or click the
button. Look at the Starter Kit. A
"scrolling" LED has to be flashing on the Board.
To halt the execution, choose Debug > Abort or click the
button (Note that this button is
only active in execution mode). The emulator system now is being halted. The execution can
be continued by entering the "Go"-Mode again.
3.3 Ending the Debugging
To end the debugging just choose the menu Debug > End debug.
MCU-AN-300217-E-V10
- 18 -
© Fujitsu Microelectronics Europe GmbH