Setting For Barcode Reader - Panasonic Toughbook CF-U1A1B1G2M Reference Manual

Barcode Reader

Setting for Barcode Reader

The following menu opens by clicking
the notification area.
Connection to Barcode
(Power Saving Mode)
Connection to Barcode
(Always-On)
Disconnect Barcode Module
Confirmation Message On
*2
Add Enter-Key code
Exit 1D Barcode Key Emulator
About 1D Barcode Key Emulator
*3
Allow Code 39
*3
Packet Mode
Exit 2D Barcode Key Emulator
About 2D Barcode Key Emulator
*1
The confirm message is closed in the following cases.
• When five seconds pass from the display message.
• When the [Close] in the message window is clicked.
• When the trigger button is pushed again.
*2
This list appears only for model with 1D Barcode Reader.
*3
This list appears only for model with 2D Barcode Reader.
(for model with 1D Barcode Reader) /
To reduce the power consumption, stop barcode reader connection within 1 minute
after reading a barcode.
Keep barcode reader active even after reading a barcode.
Stop barcode reader connection in Always-On mode or Power Saving Mode.
If the trigger button is pressed in Power Saving Mode, "Push Barcode Trigger
again to enable Barcode." message is displayed to prevent operational errors.
Add a line feed code after a barcode string.
*2 Exit barcode reader operation.
Display version Information of 1D Barcode Key Emulator.
*2
Allow Code 39 type barcode. You can change the setting by scanning Enable/Dis-
able of Code39.
Receive barcode decode data in packet mode.
Exit barcode reader operation.
*3
Display version Information of 2D Barcode Key Emulator.
*3
52
(for model with 2D Barcode Reader) icon on
*1