Husqvarna LFe 60 Operator's Manual page 16

4. Put the battery in the center of the battery charger.
5. Connect the battery charger connector (B) to the
battery to charge the battery. All indicators on the
battery charger and the battery (C) come on for 1
second. Then the power indicator (A) of the battery
charger stays on. The battery status indicator (C)
on the battery lights or flashes to show the state of
Battery status on page 11 .
charge. Refer to
Note:
The time to charge the battery from 0 to
100% is 90 minutes.
6. When the battery is fully charged, the battery status
indicator goes off.
7. Disconnect the battery charger connector.
8. Remove the battery from the battery charger.
9. Disconnect the battery charger from the mains
outlet.
To do a check of the V-belt
WARNING:
without the V-belt cover installed.
1. Make sure that the power is off. Refer to
product on page 12 .
16
C
B
Do not operate the product
To stop the
2. Remove the 4 screws that hold the V-belt cover and
remove the V-belt cover.
3. Examine the V-belt for damages and wear. Replace
the V-belt if it is necessary.
4. Examine the tension of the V-belt.
5. If the tension is not sufficient, replace the V-belt.
6. Install the V-belt cover.
1661 - 002 - 13.03.2023