Ecal Pc Graphical User Interface (Gui); Calibration Procedure - HP 85097A User Manual

Operating an ECal System

ECal PC Graphical User Interface (GUI)

ECal PC Graphical User Interface (GUI)
The following figures show you the dialog boxes that you will see on
your PC after the ECal software has been installed.
Figure 2-4

Calibration Procedure

1. Enter the configuration settings into the dialog box to match the
The button labeled
NOTE
the adapter delay settings. It is only used when performing an adapter
removal calibration. Review the information in the
Calibrations" on page
2-10
The ECal Setup Dialog Box
hardware settings.
Advanced
If you are performing an adapter removal calibration for a VNA span
of less than 150 MHz, select
settings dialog box. See
• Enter and activate the
Advanced Settings dialog box.
• Enter the adapter electrical delay data then select
(shown in Figure
2-25.
to open the ECal advanced
Advanced
Figure 2-5 on page
Adapter Electrical Delay
2-4), is used for entering
"Adapter
2-11.
from the ECal
and
Active
Chapter 2
.
OK