Image Adjustment - Panasonic WV-CW484S Operating Instructions Manual

Image Adjustment

You can manually adjust the pan/tilt/azimuth
angles, focus, and zoom while observing the
connected monitor.
Notes:
• When connecting an LCD monitor to
adjust the camera images, use an L-type
mini plug. Straight type plugs are not
available.
• Do not hold the camera by lens unit to
adjust panning, tilting, or azimuth.
• The video output to the BNC will be inter-
rupted while an LCD monitor is connect-
ed to the monitor output jack.
• While an LCD monitor is connected to
the monitor output jack, ELC (Electric
Light Control) becomes effective to
obtain a proper focus. During focus
adjustment, blooming or smear on high-
lighted objects
However, ALC (Automatic Light Control)
is effective during the normal use, and
blooming or smear is reduced.
• Adjust zoom and focus after adjusting
panning and tilting. (Refer to Step 3 and
4.)
1. Connect an LCD monitor to the monitor
output jack.
2. Pan/tilt/azimuth adjustment
• Loosen the three screws locking the pan
and tilt tables.
• Pan and tilt the table to aim the camera
at what you need to watch.
• Turn the azimuth adjuster to obtain a
level image.
• Tighten the three screws after adjusting.
may be caused.
Important:
After pan/tilt/azimuth adjustment, firmly tight-
en the panning lock screw and tilting lock
screw.
(Recommended tightening torque: 0.59 N·m
{0.44 lbf·ft})
Tilting lock screw
Panning table
3. Zoom
• Unlock the zoom lever.
• Move the lever to adjust the zoom.
• Lock the lever.
4. Focus
• Unlock the focus lever.
• Move the lever to adjust the focus.
• Lock the lever.
FAR
TELE
Azimuth
75°
(Angle adjuster)
Monitor output Jack
(3.5 diam. mini jack)
Panning lock screw
Focus lever
NEAR
NEAR
WIDE WIDE
WIDE
Zoom lever
21 21