Panasonic WV-CW484S Operating Instructions Manual page 39

→ When AUTO1 or AUTO2 is selected, LEVEL and DURATION TIME appear.
3. Select a threshold LEVEL to switch between
the color and black-and-white mode. The
default setting is HIGH.
HIGH: Switches the mode at approx. 5 lx illu-
mination.
LOW: Switches the mode at approx. 1 lx illu-
mination.
4. Select a duration time to determine whether
to switch the mode. The default setting is 30 seconds.
Available time: (Short) 10 s ↔ 30 s ↔ 60 s ↔ 300 s (Long)
5. Select a burst signal mode. The default setting is ON.
ON: Supplies the (color) burst signal with black-and-white composite video.
OFF: Supplies no burst signal.
Note: Using ON is usually recommended. Try both ON and OFF to match to connected
devices (recorders, monitors, etc.) that have different characteristics.
12. Privacy Zone Setting (PRIVACY ZONE)
Perform settings of up to eight privacy zones where you wish to veil the monitor screen.
1. Select ON(1), ON(2) or OFF for PRIVACY ZONE on page 2 of the CAMERA SETUP menu
and press the [SET] button. The default setting is OFF.
ON (1): Veils the zone with grey.
ON (2): Veils the zone with mosaic.
OFF: Displays pictures normally.
→ The ZONE NUMBER selection menu
opens.
2. Select a zone number on the top line using
the [LEFT] and [RIGHT] buttons and press
the [SET] button. The zone number followed
by an asterisk * indicates that it has been
already registered.
→ POSITION, SCALE, and a frame appear
on the menu.
3. Select →PUSH SW for POSITION and press
the [SET] button.
→ Position selection becomes available.
4. Move the picture portion to be veiled to the
center of the frame using the [LEFT],
[RIGHT], [UP], or [DOWN] button.
**BW MODE**
BW AUTO1
LEVEL HIGH
DURATION TIME .I..
S L
BURST(BW) ON
RET TOP END
**ZONE NUMBER 1/8**
RET TOP END
**ZONE NUMBER 1/8**
→PUSH SW
POSITION
→PUSH SW
SCALE
SET DEL
RET TOP END
39