Polaroid Now Generation 2 User Manual page 6

Instant camera

Hide thumbs

page of 6

/ 6
Troubleshooting
Bookmarks

Safety Information

• The supplied battery charging cable

has been tested to work with the Apple

iPhone power

iPhone power adaptors. While it can be

adaptors. While it can be

Caution Risk of electric shock — Do not

Caution

Risk of electric shock — Do not

used in other USB ports

used in other USB ports e.g. computer,

open/ Disassemble the motorized roller

USB power adaptors, TVs, cars etc.,

system

correct operation cannot be guaran-

• Do not disassemble the device. Incor-

teed.

rect reassembly can cause electrical

• When the device is no longer in use,

shock if the device is used again.

please recycle it properly.

• Do not immerse the device in water or

other fluids.

Usage Environment

• Do not operate the device in a high

• To protect the high-precision technology

humidity environment or very dusty

contained in this device, never leave the

environments.

camera

camera in the following environments for

in the following environments for

• Do not attempt to tamper with, adjust or

extended periods of time: high tempera-

remove the battery and/or the electron-

ture (+42°C/108°F), high humidity, places

ics located below the rollers behind the

with extreme changes in temperature (hot

device's film door.

and cold), direct sunlight, sandy or dusty

• Do not attempt to remove the door

environments such as beaches, damp

itself as it is connected electronically

places, or places with strong vibrations.

to the body of the device. Doing so is

• Do not drop the device or subject it to

unsafe, will likely damage your device,

severe shocks or vibrations.

and will void your warranty.

• Do not push, pull or press on the lens

• Do not insert metal objects into the

surface.

device.

• Do not insert any objects into the rollers

Compliance

or gears.

• Keep small children and infants away

Important directions for using

from device to avoid them being injured

Lithium–Ion Batteries

by the device's moving parts.

1. Do not throw into fire.

• Do not use or store the device near any

2. Do not short circuit.

heat source or any type of equipment

3. Do not disassemble.

that generates heat, including stereo

4. Do not continue to use when damaged.

amplifiers.

5. Dispose correctly after use.

• Do not use the device near flammable

6. Keep away from water.

or explosive gases.

7. Do not charge when the temperature is

• Do not charge the device if you notice

below freezing.

any unusual odors, noise or smoke.

• Do not attempt to disassemble the

EU Declaration of Conformity

film's battery or modify it in any way (if

Hereby, Polaroid International B.V.

using 600-type film). If battery fluid gets

declares that the Polaroid Now analog

in your eyes, immediately rinse your

instant camera is in compliance with the

eyes with fresh, cold running water and

essential requirements of the Electromag-

seek medical attention immediately.

netic Compatibility Directive (2014/30/

• Do not cover the flash.

EU), Low Voltage Directive (2014/35/EU)

and RoHs Directive (2011/65/EU) and

Battery and Charger

other relevant provisions, when used for

• This device uses a custom lithium-ion

its intended purpose.

battery that is non-removable and

FCC Compliance Statement

mounted inside the camera body. No

This device complies with Part 15 of the

other type of battery can be used.

FCC Rules. Operation is subject to the fol-

Battery replacement can only be done

lowing two conditions: (1) this device may

by authorized service centers. The

not cause harmful interference, and (2)

battery will provide many years of

this device must accept any interference

service if properly used.

received, including interference that may

• Power consumption varies depending

cause undesired operation.

on the environment the device is used

Caution The user is cautioned that

Caution

The user is cautioned that

in and how the device has been stored.

changes

Used immediately after full charge, the

or modifications not expressly approved

battery will power the processing of up

to 15 film packs.

the party responsible for compliance

• Once the battery energy level falls

could void the user's authority to operate

below a certain level, the device will

the equipment. This equipment must not

no longer process film. The LED will

be co-located or operated in conjunction

blink and signal when it needs to be

with any other antenna or transmitter.

recharged. This is to avoid a photo

Note This equipment has been tested

Note

This equipment has been tested

getting stuck as it is being processed

and found to comply with the limits for

through the roller system.

a Class B digital device, pursuant to

• The rechargeable battery is not fully

part 15 of the FCC rules. These limits

charged

are designed to provide reasonable

at the time of purchase. Charge the

protection against harmful interference in

battery fully with the USB charging

a residential installation. This equipment

cable (provided). This usually takes 1-2

generates, uses and can radiate radio

hours (can vary depending on usage).

frequency energy and, if not installed and

used in accordance with the instructions,

may cause harmful interference to radio

communications. However, there is no

e.g. computer,

guarantee that interference will not occur

in a particular installation. If this equip-

ment does cause harmful interference to

radio or television reception, which can

be determined by turning the equipment

off and on, the user is encouraged to

try to correct the interference by one or

more of the following measures:

• Reorient or relocate the receiving

antenna.

• Increase the separation between the

equipment and receiver.

• Connect the equipment into an outlet

a circuit different from that to which

the receiver is connected.

• Consult the dealer or an experienced

radio/TV technician for help.

This equipment complies with FCC

radiation exposure limits set forth for an

uncontrolled environment. End user must

follow the specific operating instructions

for satisfying RF

for satisfying

RF exposure compliance.

exposure compliance.

Industry Canada (IC)

CAN ICES-003(B)/NMB-003(B)

This device complies with part 15 of the

FCC Rule and Industry Canada license–

exempt RSS standard(s). Operation is

subject to the following two conditions:

(1) This device may not cause harmful

interference, and (2) this device must ac-

cept any interference received, including

interference that may cause undesired

operation.

This symbol means that according

to local laws and regulations your

product should

be disposed of separately from house-

hold waste. When this product reaches

its end of life, take it to a collection

point designated by local authorities.

Some collection points accept products

for free. The separate collection and

recycling of your product at the time

of disposal will help conserve natural

resources and ensure that it is recycled in

a manner that protects human health and

the environment.

Polaroid International B.V.

1013AP Amsterdam

The Netherlands

End of life disposal warning: When the product has come to the end of life, dispose of it in

accordance with local regulations. This product is subject to the EU directive 202/96/EC

on Waste Electrical and Electronic Equipment (WEEE) and should not be disposed as unsorted

municipal waste.

Made in China for and distributed by Polaroid International B.V., 1013 AP, Amsterdam, The

Netherlands. The POLAROID word and logos (including the Polaroid Classic Border Logo) and

Polaroid Now are protected trademarks of Polaroid.

Table of Contents

Polaroid Now Generation 2 User Manual page 6

Related Manuals for Polaroid Now Generation 2