HP ProLiant DL20 Gen10 User Manual page 109

17. Install the access panel .
18. Install the server into the rack .
19. Connect all peripheral cables to the server.
20. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
21. Power up the server .
22. If removed, install the front bezel .
23. If you plan to use the iLO Dedicated Network Port, use the iLO web interface to enable this port.
For more information, see the Enabling the iLO Dedicated Network Port through the iLO web interface section in the iLO user guide
on the Hewlett Packard Enterprise website Hewlett Packard Enterprise website .
The installation is complete.
Installing the M.2 SSD/dedicated iLO/serial port enablement board 109