Use of Wireless Manager 3.0
Displaying the sender, sender's name
Checkmark [Show the sender] and enter the name in [Sender].
In meeting mode, the entered [Sender's name] will be shown in combination at the
right bottom of image sent to the projector. The above information is not displayed in
live mode or in presentation mode. If [Presentation mode] is not checkmarked in
presentation mode, the information is displayed on each image transmission.
Setting a shortcut key
Go to [Option] and select [Others].
[Live mode]:
This function turns ON/OFF the live mode.
[Full screen transmission]:
This function transmits the entire image on the
PC screen to the projector.
[Presentation]:
Displays a presentation screen.
[Capture]:
Displays a capture screen.
Note:
The screen of Wireless Manager 3.0 must be activated when using the shortcut
key. Note that, if any other application is running at the same time, and when the
set shortcut key is also used by that application, then this function works in a
totally different way.
Setting automatic play
See the section of automatic play of "presentation mode". (See page 43)
Setting Simple Connection
When Simple Connection is used, the user may disable the screen saver.
If the system hangs up due to any anomaly during Simple Connection, the user can
press the [Restore] button to bring the network settings into the previous state.
However, this cannot be guaranteed against all abnormal conditions.
45