POSITION Menu
See "Navigating through
the MENU" on page 26.
H - POSITION
You can move the projected image horizontally for fine
adjustment.
Move
left
V - POSITION
You can move the projected image vertically for fine
adjustment.
Move
down
DOT CLOCK
If you have interference patterns on the projected
image, which is sometimes referred to as moire or
noise, you can minimize it by pressing I H to adjust the
clock frequency.
NOTE:
CLOCK PHASE
If you require further adjustment for the same reason as
the DOT CLOCK adjustment, you can fine adjust the
timing of the clock. Press I H to adjust.
NOTE:
Move
right
Move
up
If the projecting signal's dot clock frequency is
higher than 150 MHz, the adjustment may not
make a difference.
If the projecting signal's dot clock frequency is
higher than 150 MHz, the adjustment may not
make a difference.
CLOCK PHASE is not available with
1 125 (1 080)/50i, 1 125 (1 080)/60i,
1 125 (1 080)/50p, 1 125 (1 080)/60p,
1 125 (1 080)/24p, 750 (720)/50p and
750 (720)/60p signals using the COMPONENT
connection.
E
- 31
NGLISH