Switching The Projector On/Off; Power Cord; Power Indicator - Panasonic PT-AX100U Operating Instructions Manual

Switching the projector on/off

Power cord

Ensure all the input devices are connected and turned off before connecting the Power cord.
Connecting
1. Make sure the shape
of the power cord plug
and the AC IN
connector on the back
of the projector match,
then push the plug all the way in.
2. Connect the Power cord to a wall socket.
NOTE:
Do not use any other Power cord than the one supplied with the projector.
Do not force the connector as this may damage the projector and/or the power cord.
Dirt or dust build-up around plugs may cause fire or electrical hazards.
Switch off the power to the projector when not in use.

POWER indicator

Indicator status
No illumination or flashing
RED
Flashing
GREEN
ORANGE
Flashing
NOTE:
While the projector is cooling the lamp, do not switch the MAIN POWER off or unplug the Power cord.
POWER indicator
The MAIN POWER is switched off.
Lit The MAIN POWER is switched on and the projector is standby.
The POWER is switched on and the projector is getting ready to project.
Lit The projector is ready to project.
Lit The POWER is switched off and the projector is cooling the lamp.
The POWER is switched on again when cooling the lamp and recovering
to projection mode. Recovery may take a while.
Disconnecting
1. Make sure the MAIN POWER is switched off
and unplug the Power cord from the wall
socket.
2. Hold the plug and unplug the Power cord
from the AC IN connector on the back of the
projector.
Status
E - 19
NGLISH