Table of Contents
Advertisement
COM PU LIN K Remot e Cont r ol Syst em
The COM PU LINK r emote contr ol system allows you to oper ate JVC audio components thr ough the r emote sensor on
the r eceiver.
To use this remote control system, you need to connect JVC audio
components through the COMPU LINK (SYNCHRO) jacks (see
below) in addition to the connections using cables with RCA pin
plugs (see pages 5 and 6).
• Make sure that the AC power cords of these components are
unplugged before connection. Plug the AC power cords only after
all connections are complete.
COMPU LINK – 4
(SYNCHRO)
Notes:
• There are four versions of COMPU LINK remote control system.
This receiver is equipped with the fourth version — COMPU LINK-
4. This version is added systematic operations with the CD recorder
to the previous version — COMPU LINK-3.
• If your audio component has two COMPU LINK jacks, you can use
either one. If it has only one COMPU LINK jack, connect it so that it
is the last item in the series of components. (For example, the
turntable or CD player in the diagram above.)
• To operate the cassette deck or MD recorder using the COMPU
LINK remote control system, set the source name correctly. (See
page 16.)
• Refer also to the manuals supplied with your audio components.
This remote control system allows you to use four functions listed
below.
Remot e Cont r ol t hr ough t he Remot e Sensor on t he
Receiver
You can control the connected audio components through the remote
sensor on the receiver using this remote control. Aim the remote
control directly at the remote sensor on the receiver. For details, see
pages 49 and 50.
41
Aut omat ic Sour ce Select ion
When you press the play (3 3 3 3 3 ) button on a connected component or
on its own remote control, the receiver automatically turns on and
changes the source to the component. On the other hand, if you
select a new source on the receiver or on the remote control, the
selected component begins playing immediately.
In both cases, the previously selected source continues playing
without sound for a few seconds.
Aut omat ic Power On/ Off (St andby): only possible
CD player
wit h t he COM PU LIN K-3 and COM PU LIN K--4
connect ion
The connected components turn on and off (standby) along with the
CD recorder
receiver.
When you turn on the receiver, one of the connected components
will turn on automatically, depending on which component has been
Cassette deck
previously selected.
or
When you turn off the receiver, the connected components will turn
MD recorder
off (standby).
Synchr onized Recor ding
Synchronized recording means the cassette deck (or MD recorder)
starts recording as soon as a CD begins playing.
To use synchronized recording, follow these steps:
Turntable
1. Put a tape in the cassette deck (or an MD in the
2. Press the record (¶) button and the pause (8)
3. Press the play (3) button on the CD player.
Notes:
• During synchronized recording, the selected source cannot be
• If the power of any component is shut off during synchronized
MD recorder), and a disc in the CD player.
button on the cassette deck (or MD recorder) at
the same time.
This puts the cassette deck (or MD recorder) into recording
pause.
If you do not press the record (¶) button and pause (8) button at
the same time, the synchronized recording feature will not
operate.
The source changes on the receiver, and as soon as play starts,
the cassette deck (or MD recorder) starts recording. When the
play ends, the cassette deck (or MD recorder) enters recording
pause, and stops about 4 seconds later.
changed.
recording, the COMPU LINK remote control system may not
operate properly. In this case, you must start again from the
beginning.
Advertisement
Table of Contents
