Panasonic KX-TG2970B Operating Instructions Manual page 77

General
Problem
The unit does not work.
"Recharge battery" is
displayed, " " flashes or
the cordless handset beeps
intermittently.
"Charge for 6 HRS" and
" " are displayed and the
cordless handset does not
work.
You charged the battery fully,
but "Recharge battery" is
still displayed and/or "
continues to flash, or "Charge
for 6 HRS" and "
displayed.
The CHARGE indicator does
not go out after the battery has
been charged.
If you cannot solve your
problem
For assistance, please call: 1-800-ADT-ASAP
• Check the settings (p. 10–13).
• Check whether the dialing mode setting is
correct (p. 19).
• Fully charge the battery (p. 12).
• Clean the charge contacts and charge again
(p. 13).
• Check battery installation (p. 11).
• Unplug the base unit's AC adaptor to reset it.
Plug in, and try again.
• The cordless handset has not been
registered to the base unit. Register the
cordless handset (p. 27, 69).
• Re-install the battery (p. 11) and fully charge
it.
• Verify the correct AC adaptor is connected to
the base unit.
• Fully charge the battery (p. 12).
• The battery has been discharged. Fully
charge the battery (p. 12).
• Clean the charge contacts and charge again
(p. 13).
• The battery may need to be replaced. If you
"
install a new battery, fully charge it (p. 11, 13).
" are
• This is normal.
• Read the Operating Instructions or
Quick Set-Up Guide.
• Please call 1-800-ADT-ASAP
Troubleshooting
Cause & Remedy
77