Table of Contents
Advertisement
Using the Cordless Handset
(Remote Operation)
If "
" flashes, there are new messages. If there are only old messages or no
PLAY
messages, "
" will be displayed but will not flash.
PLAY
To play back messages
1
Press the soft key (
• A beep sounds and the number of new
messages will be announced from the speaker,
and new messages will be played.
• To switch to the receiver, press [
back to the speaker, press [
• When you have no new messages, the unit
announces "No new messages. All message
playback" and plays back all messages.
• To play all messages, press [5].
• If you do not press any buttons, the voice menu
will start (see below).
2
To end remote operation, press [OFF].
• "
" will not disappear after listening to messages.
PLAY
• During playback, the display shows the message number.
• At the end of the last message, "End of final message" is heard. The unit will
announce the remaining recording time if it is less than 5 minutes.
• When there are no messages, the unit announces "No messages".
• If a call is being received during playback, the unit rings and playback stops. To
answer the call, press [
after hanging up.
Voice menu
If you do not press any buttons at the end of the last message and hear "End of final
message", the cordless handset will start the following voice menu.
"Press 4 to play back new messages. Press 5 to play back all messages."
• You can press buttons for other playback options (p. 58) even if the voice menu
has started.
• If you do not press any button within 10 seconds after the voice menu, the
cordless handset will exit remote operation.
To turn the Answering System on
Press [8] during playback.
To turn the Answering System off, press [0] during playback.
For assistance, please call: 1-800-ADT-ASAP
Listening to Messages
Handset
)
.
PLAY
]. To switch
].
] or [
]. For playback, start again from the beginning
Ex. New messages exist.
Received calls
A D T
PANIC
PLAY
57
Advertisement
Table of Contents
